Get a Quote
Get A Quote

Get A Quote

Please complete this form
Captcha validation is required.

Push Type Internal Tube Cutter - ATP Series

Used to cut the tube from inside.

Features of Push Type Internal Tube Cutters - ATP Series

  • POWERMASTER "Push Type" Internal Tube Cutters quickly cuts through the walls of ferrous tubes in Condensers and Heat Exchangers as a step in their removal from the tube sheet.
  • This sturdy "Push Type" Internal Tube Cutters can be used with a portable Electric or Air Drill Motor.
  • "Push Type" Cutters are simple to operate. Merely insert it into the tube, apply power, press inward and the tube can be cut in a few seconds. Releasing of inward pressure automatically retracts the Cutter Bit. These Tube Cutters are equipped with an adjustable collar suitable for reaching into tubes at various depths.
  • The replaceable cutting bit can be interchanged in a few seconds. Standard adjustable reach is 4”(101.6mm) and they are available in optional increments of 2”(50.8mm). “A” reach = 6”(152.4mm). “B” reach = 8”(203.2mm). “C” reach = 10”(254.0mm) etc.
  • All Tube Cutters come with a complete set of pilots covering the entire range of tube thickness for a particular tube O.D. (ATP-625 tube cutters come with a built in pilot suitable for one tube ID only.)
    All Tube Cutters are available for MM tube sizes also. Please enquire.
Sizes Available of ATP Series Tube Cutters 5/8" O.D. TO 1 1/2" O.D.
Models Available of ATP Series Tube Cutters ATP-625 TO ATP-1500